DIY Reset for the Oil Change “MAINT REQD” Light on a 2007–2011 Toyota Camry
Introduction
On 2007–2011 Camry models, the “MAINT REQD” light is a mileage-based reminder for oil service, not a failure warning. Once the oil change is complete, you can reset this light with the odometer button in less than a minute.
Tools and prep
- Ignition key
- Parked on level ground with the transmission in Park
- Doors closed, so no extra chimes distract you
Step-by-step: Resetting the MAINT REQD light
- Turn the key to ON
- Insert the key and turn it to ON without starting the engine.
- You should see all the warning lights illuminate briefly.
- Select “Trip A”
- Use the trip/ODO button to cycle through ODO, Trip A, and Trip B.
- Stop when Trip A is displayed on the cluster.
- Turn the key OFF
- Turn the ignition fully to OFF while Trip A is still displayed.
- Press and hold the trip/ODO button
- Press and hold the same button you used to select Trip A.
- Keep holding it down firmly.
- Turn the key back to ON (still holding the button)
- While holding the button, turn the key to ON, again without starting the engine.
- The MAINT REQD light will begin to flash, and the odometer will show a series of dashes and zeros as it resets.
- Wait for the light to turn off
- Keep holding the button until the MAINT REQD light goes out and the odometer returns to normal.
- Release the button, then start the engine to verify the light stays off.
When you should reset it
- Immediately after each oil change and filter replacement.
- Do not reset if you intentionally postponed service; the reminder is there for engine health.
Common mistakes and fixes
- Wrong display: The reset usually only works when Trip A is selected, not ODO or Trip B.
- Timing: If you let go of the button too soon or start the engine, the sequence will fail—just switch off and try again.
